Cleaning products
Cleaning products for 4.5 and 5.5 mm airguns. Here you will find a UMAREX gun cleaning tool kit for barrel and action care after range sessions. A clean bore keeps the accuracy you count on when training between hunting seasons.
Cleaning products
An airgun is a hunter's training tool: you sharpen your marksmanship between seasons and teach young shooters safe gun handling without burning through centrefire ammunition. For an air rifle or pistol to stay accurate, its barrel needs cleaning just as regularly as your hunting rifle. This category holds cleaning products for 4.5 and 5.5 mm airguns.
Why an airgun needs cleaning products
Lead pellets leave deposits in the bore with every shot, and CO2 and PCP systems attract moisture that starts corrosion. A fouled barrel changes the pellet's path, groups open up, and you can no longer tell if the fault is your hold or the gun. Regular cleaning brings back a repeatable shot. For a hunter this matters twice over: training with an inaccurate gun builds bad habits that you later carry into the forest.
What you will find in this category
The category currently carries the UMAREX gun cleaning tool kit for 4.5 and 5.5 mm calibres. It is a compact set covering the core maintenance jobs on an airgun: bore cleaning and external care of the action. One kit serves both an air pistol and a rifle, so you do not need separate tools for each gun. UMAREX is one of the best-known airgun makers in Europe, and its maintenance tools are matched to its own guns.
Maintenance jobs you will do with the kit
With the UMAREX kit you will handle all the everyday care an airgun asks for, from a quick bore pass after a practice session to preparing the gun for winter storage. The jobs below are worth turning into a habit, so the gun shoots the same every time and your sight settings stay valid.
Bore cleaning after shooting
After a longer session at the range or in the yard, run the rod with a brush and dry patches through the barrel until they come out clean. It takes a few minutes and your accuracy stays stable.
Removing lead fouling
When your groups visibly widen, a layer of lead has built up in the bore. Remove it thoroughly: pass the brush through several times, then patch until no grey traces remain.
External and action care
Wipe metal surfaces dry after a damp day outdoors and cover them with a thin protective film against corrosion. Avoid excess oil: it attracts dust and can reach places where it does harm.
Preparing for storage
Before putting the gun away for a longer break, clean the bore and check the seals. A gun stored clean and dry shoots the same in spring as it did in autumn.
How to choose cleaning products
When picking cleaning products for an airgun, four things decide the choice: calibre, rod length, how gentle the materials are, and how easy the kit is to carry. The same order applies both to a first kit and to replacing a worn one:
- Check the calibre: 4.5 mm (.177) and 5.5 mm (.22) need brushes of different diameters, so pick a kit that covers your gun's calibre.
- Look at rod length: a short rod is enough for a pistol, a rifle barrel needs a longer or sectioned rod.
- Choose gentle materials: an airgun bore is softer than a firearm's, so aggressive steel brushes do not belong in it.
- Think about transport: a compact case fits into a gun bag and travels with you to the range.
Practical field advice
Clean from the breech end if the gun's design allows it, so you do not damage the muzzle crown that accuracy depends on. Do not use standard firearm solvents on spring-piston rifles: their vapours can ignite in the compression chamber, so dry cleaning is usually the safe route for airguns. After every session in damp weather, wipe the metal dry before the gun goes back into its case, and confirm your zero after any deep clean.
Cleaning is only one part of airgun accessories. Have a look at CO2 cartridges, targets and target holders for practice, and magazines and other parts. If you are not sure the kit fits your gun, write to us and we will advise.